Fret Slot Depth On A New Finger Board -

Simply hold the flat edge against the fret tang, note the height of the tang against the reference lines, fit the appropriate curved edge into the slot, and

Fret Slot Depth On A New Finger Board - The standard is mm for regular frets and mm for replacement frets You can use a carpenter's square to guide your fret saw (use the straight side of

Simply hold the flat edge against the fret tang, note the height of the tang against the reference lines, fit the appropriate curved edge into the slot, and

40 shining crown slot I cut the slots straight on a table saw before cutting the radius I usually cut them about deep, then the radius reduces the depth on

The kerf of the saw is the cutting width of the blade, so it determines the thickness of the slot you will cut The saw you use, and the fret slot you create,

fret slot saw What is the nominal fret slot width? If you target is , you will not get that with a cutter If your target is , you might

fret slot depth gaugeBe sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough