Fret Wire Specifications

Be sure your fretwire will fit! Don't wait until after you've installed a fret to discover the slot wasn't quite deep enough Dan Erlewine developed this

They are used for cutting the fret slots in fingerboards and for executing the clean-up pass when cutting inlay pockets The enhanced rigidity of the

fret slot saw However, the calculator will report the disance as This is inconsequential, as nobody can saw a fret slot that

fret slot depth When it comes to CAM I use the 2D trace and pick my fret slotting bit as the tool, and the lines to trace Then use a negative depth to get the